● 980nm diode laser for veins and vascular removal
● Fiber coupled with SMA905 connector
● Capacity screen with A9 control module
● US original diode array
● Output power calibration at the end of fiber
Principle of 980nm vascular removal laser
Based on theory of “selective laser photothermal”, 980nm diode laser system uses specific 980nm wavelength to penetrate into skin for vasular treatment. The laser irradiation lesion, under laser irradiation, hemoglobin and red pigment capillaries to maximize absorption of laser energy, solidification occurs, blocking blood vessels, capillaries shrink, leading to intravascular coagulation, finally metabolic degradation. Due to the specific 980nm wavelength of the laser, it assures normal intact skin tissue architecture in the greatest degree during the vascular treatment and also ensures a good therapeutic effect without damaging superfacial skin.
Applications of 980 nm diode laser
● Vascular lesions
● Proliferative lesion
● Spider veins
● Liner angitelectasis
● Cherry angiomasA Gold standard in hair removing
Veins removal treatment by 980nm diode laser
Technical specifications of 980nm medical diode laser vascular removal beauty machine with 30W power
Vascular laser model | HS-890 |
Wavelength | Diode laser 980nm |
Laser output power | 15W or 30W |
Output modes | CW, Single or Repeat pulses |
Pulse width | 5-400ms |
Repetition rate | 1~50HZ |
Transmission system | Fiber of 300um with SMA 905 connector |
Operate Interface | 8 inch touch screen |
Warranty | Technical support forever |
Voltage | AC 100V or 230V, 50/60HZ |
Demension | 28*27*37cm (L*W*H) |
Weight | 8Kgs |
Advantages of 980nm diode laser spider vein removal machine
1. The advanced laser technology for red blood veins/vascular/spider veins removal in contrast with high frequency in the market.
2. 15 or 30W energy to satisfy different requirements.
3. Three modes: CW Pulse, Repeat Pulse and Single for optional.
4. Short time operation, no injury, no bleeding, no burning, redness or scar.
5. The obvious effectiveness: Only one or two treatments are required
6. Output power calibration at end of fiber